shared_key
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
shared_key [2008/11/08 01:45] – fixed typo darkaudax | shared_key [2010/08/29 19:48] – Fixed channel/frequency graph link mister_x | ||
---|---|---|---|
Line 107: | Line 107: | ||
In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
- | To match the frequency to the channel, check out: | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
- | http://www.rflinx.com/help/calculations/# | + | |
=== Troubleshooting Tips === | === Troubleshooting Tips === |
shared_key.txt · Last modified: 2018/03/11 20:19 by mister_x