airodump-ng
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
airodump-ng [2022/02/09 00:39] – [Description] add link to wpa_capture mister_x | airodump-ng [2022/05/01 21:03] (current) – [What's the meaning of the fields displayed by airodump-ng ?] PWR: Updated some wording mister_x | ||
---|---|---|---|
Line 104: | Line 104: | ||
^Field^Description^ | ^Field^Description^ | ||
|BSSID|MAC address of the access point. In the Client section, a BSSID of "(not associated)" | |BSSID|MAC address of the access point. In the Client section, a BSSID of "(not associated)" | ||
- | |PWR|Signal level reported by the card. Its signification depends on the driver, but as the signal gets higher | + | |PWR|Signal level reported by the Wi-Fi adapter. Its signification depends on the driver, but as you get closer to the AP or the station, the signal gets higher. It usually is the [[https:// |
|RXQ|Receive Quality as measured by the percentage of packets (management and data frames) successfully received over the last 10 seconds. | |RXQ|Receive Quality as measured by the percentage of packets (management and data frames) successfully received over the last 10 seconds. | ||
|Beacons|Number of announcements packets sent by the AP. Each access point sends about ten beacons per second at the lowest rate (1M), so they can usually be picked up from very far.| | |Beacons|Number of announcements packets sent by the AP. Each access point sends about ten beacons per second at the lowest rate (1M), so they can usually be picked up from very far.| |
airodump-ng.txt · Last modified: 2022/05/01 21:03 by mister_x